Sanyo 9.1 - Manual (Page 14)

English
12
For Mac OS X users
Mounting your camera
1 Set the camera to the card reader mode (page 8).
h The camera is recognized as a drive and appears as an icon named
[XACTI] (or [XACTI_INT] in case of the camera’s internal memory) on
the Desktop.
h Double-click on the [XACTI] (or [XACTI_INT] in case of the camera’s
internal memory) icon, and you can process the contents of the card
installed in your camera exactly like you would the data in the other
computer drives.
Dismounting the camera
CAUTION
i To disconnect your camera, be sure to follow the procedure below. Failure
to follow this procedure may cause faulty operation of your computer or
loss of card data.
1 Drag the [XACTI] (or [XACTI_INT] in case of the camera’s internal
memory) icon for your camera on the Desktop to the trashcan.
h The [XACTI] (or [XACTI_INT] in case of the camera’s internal
memory) icon disappears from the Desktop.
h You can now disconnect your camera.
CAUTION
When using in a Mac OS X Classic environment
i It is not possible to save or load data directly to or from the card installed in
the camera. The data must first be saved once to your hard disk.