Sony FE40L - Manual (Page 21)

21
Turning Off the Power
Pr
oj
ec
tin
g
t
h
e
P
ict
ur
e
To adjust the tilt of the installation
surface
If the projector is installed on an uneven
surface, use the adjusters to keep the
projector level.
• Be careful not to let the projector down on
your fingers.
• Do not push hard on the top of the projector
with the adjuster extended.
It may cause a malfunction.
Turning Off the
Power
1
Press the ?/1 key.
“POWER OFF? Please press ?/1 key
again.” appears to confirm that you want
to turn off the power.
The message disappears if you press any
key other than the ?/1 key, or if you do not
press any key for five seconds.
2
Press the ?/1 key again.
The ON/STANDBY indicator flashes in
green and the fan continues to run to
reduce the internal heat. Also, the ON/
STANDBY indicator flashes quickly.
During this time, you will not be able to
light up the ON/STANDBY indicator
again with the ?/1 key.
3
Unplug the AC power cord from the
wall outlet after the fan stops running
and the ON/STANDBY indicator
lights in red.
When you cannot confirm the on-
screen message
When you cannot confirm the on-screen
message under certain conditions, you can
turn off the power by holding the ?/1 key for
about one second instead of the steps 1 and
2 above.
The internal circuitry of the Off & Go and
Direct Power On/Off functions may cause the
fan to continue to operate for a short time even
after the ?/1 key is pressed to turn off the
power and the ON/STANDBY indicator
changes to red.
Notes
Turn to
adjust
Adjusters
Note
Note