SUPER MICRO Computer SUPERO H8QG6+-F - Manual (Page 82)

B-6
H8QG6/i+-F Serverboard User’s Manual
Checkpoint Code Description
99h Any initialization required after the option ROM test has completed. Confi guring the timer data
area and printer base address next.
9Ah Set the timer and printer base addresses. Setting the RS-232 base address next.
9Bh Returned after setting the RS-232 base address. Performing any required initialization before
the Coprocessor test next.
9Ch Required initialization before the Coprocessor test is over. Initializing the Coprocessor next.
9Dh Coprocessor initialized. Performing any required initialization after the Coprocessor test next.
9Eh Initialization after the Coprocessor test is complete. Checking the extended keyboard, keyboard
ID, and Num Lock key next. Issuing the keyboard ID command next.
A2h Displaying any soft errors next.
A3h The soft error display has completed. Setting the keyboard typematic rate next.
A4h The keyboard typematic rate is set. Programming the memory wait states next.
A5h Memory wait state programming is over. Clearing the screen and enabling parity and the NMI
next.
A7h NMI and parity enabled. Performing any initialization required before passing control to the
adaptor ROM at E000 next.
A8h Initialization before passing control to the adaptor ROM at E000h completed. Passing control to
the adaptor ROM at E000h next.
A9h Returned from adaptor ROM at E000h control. Performing any initialization required after the
E000 option ROM had control next.
Aah Initialization after E000 option ROM control has completed. Displaying the system confi guration
next.
Abh Uncompressing the DMI data and executing DMI POST initialization next.
B0h The system confi guration is displayed.
B1h Copying any code to specifi c areas.
00h Code copying to specifi c areas is done. Passing control to INT 19h boot loader next.