SUPER MICRO Computer SUPERO H8QG6+-F - Manual (Page 31)

Chapter 2: Installation
2-5
Note: Memory modules of 1 GB, 2 GB, 4 GB, 8 GB, 16 GB or 32 GB size are
supported. It is highly recommended that you remove the power cord from the
system before installing or changing memory modules. Please refer to our web site
for memory that has been tested on the H8QG6/i+-F serverboard.
Memory Support
The H8QG6/i+-F serverboard supports thirty-two (32) single/dual/tri/quad-channel,
DDR3-1600/1333/1066 Mhz SDRAM memory modules.
Populating four adjacent slots at a time with memory modules of the same size and
type will result in interleaved (128-bit) memory, which is faster than non-interleaved
(64-bit) memory.
Maximum Memory
The H8QG6/i+-F serverboard supports a maximum memory of up to 256 GB of
ECC/Non-ECC UDIMM or up to 1 TB of ECC RDIMM SDRAM.
Figure 2-1. DIMM Installation
To I n s t a l l : I n s e r t
module vertically and
press down until it
s n a p s i n t o p l a c e .
Pay attention to the
alignment notch at
the bottom.
To R e m o v e : U s e
your thumbs to gently
push the release tabs
near both ends of the
module. This should
release it from the
slot.
Top View of DDR3 Slot
Release Tab Release Tab
Note: Notch should align with
the receptive key point on
the slot.
Notch Notch
Front View