Projector ready lights and projector status, Contacting smart technical support – Smart Technologies Unifi 45 User Manual
Page 46

38
Troubleshooting Your Interactive Whiteboard System
99-00881-20 A0
Projector Ready Lights and Projector Status
The three projector ready lights are located on the underside of the projector. They are marked Lamp,
On/Standby and Temp (for temperature).
Contacting SMART Technical Support
SMART product, you might want to contact your
be able to resolve the issue without delay.
Lamp
status light
On/Standby
status light
Temp
status light
Projector Status
Off
Off
Off
The projector isn’t receiving power.
Check the connection, power supply and power
switch at the back of the projector.
Off
Solid green
Off
The projector is operating normally.
Off
Solid red
Flashing red
The projector is overheating. Make sure that nothing
is blocking the airflow into or away from the internal
fans. Turn off, unplug and reconnect the power cord,
wait a few minutes, and then turn on the system.
Off
Amber
Off
The projector is in Standby mode, ready to be
turned on.
Solid red
Solid red
Off
There is a lamp power error. If the lamp warning
recently appeared, unplug the power cord and
change the lamp. Otherwise shut down, unplug
and reconnect the power cord, wait a few minutes,
and then turn on the system.
Flashing amber
Solid red
Off
There is a power failure, or the lamp cover isn’t
installed correctly. Unplug the power cord, check
and re-attach the cover if necessary, reconnect
the power cord, wait a few minutes, and then turn
on the system.
Different than
any other status
previously listed
Different than
any other status
previously listed
Different than any
other status
previously listed
Other errors have occurred that might require
diagnosis and professional work. Unplug and
reconnect the power cord, wait a few minutes,
and then turn on the system. If nothing changes,
call y
the problem.