Smart Technologies Smart Board For Flat-PanelDisplays 99-00668-00 - Manual (Page 23)

99-00668-00 REV B0 Installing the Interactive Whiteboard 15
1. Connect the MOD8 cable to the corresponding port on the back of the overlay. You connected
the other end of this cable to either the pen tray or the controller earlier.
2. Connect the power supply connector to the overlay’s power port.
NOTE: The power supply connector doesn’t go all the way in.
To complete the installation
MOD8 Cable
Port
NOTE: Your configuration
may have a controller
instead of a pen tray.
Power Supply
Power Port
Power Connector
NOTE: Your configuration
may have a controller
instead of a pen tray.