Connecting to a stereo system (line out), 57 connecting to a stereo system (line out) – Sony MZ-NH900 User Manual
Page 57

57
Connecting to a stereo
system (LINE OUT)
You can listen to the playback sound from
connected component. Connect the i/
LINE OUT jack of the recorder to the
LINE IN jacks of an amplifier or a tape
player with a line cable.
When connecting a line cable to the i/
LINE OUT jack of the recorder, be sure to
set the “Audio Out” parameter for the i/
LINE OUT jack.
This operation can be done on the
recorder only.
1
Remove the headphones/earphones
with a remote control from the
recorder.
2
Enter the menu and select “Useful” -
“Audio Out”.
3
Turn the jog dial until “Line Out”
appears in the display, and then press
NENT to enter the selection.
•
If the “Audio Out” parameter for the i/LINE
OUT jack is set to “Line Out”, Virtual
Surround or 6-Band Equalizer will not
function.
•
The “Audio Out” parameter for the i/LINE
OUT jack cannot be set to “Line Out” when
the remote control is connected.
•
When you connect the headphones/earphones
directly to the recorder, make sure to set the
“Audio Out” parameter for the i/LINE OUT
jack to “Headphone” in step 3.
•
When the “Audio Out” parameter for the i/
LINE OUT jack is set to “Line Out”, do not
connect the headphones/earphones. The sound
from the headphones/earphones will be very
loud and the sound distortion occurs.
•
If the recorder is connected to a component
such as an active speaker and the “Audio Out”
parameter for the i/LINE OUT jack is set to
“Headphone”, make sure to set the “Beep”
setting to “Beep Off” (page 75).
Stereo System,
etc.
2 phono plugs
Stereo mini-
plug
To LINE IN
L
(white)
R
(Red)
Line cable
To i/LINE OUT
NAVI/MENU
5-way control key
(NENT, .,
>
)
Jog dial
Notes