Sundance Spas 850 - Manual (Page 27)

Page 23
G. Seek / Manual Tune
Press tune/seek-up button (13) once to automatically tune the next higher
station. Press tune/seek-down button (14) once to automatically tune the
next lower station. To manually tune to a specific station frequency, press
and hold either tune/seek button for at least 2 seconds. Holding either
button down will increase or decrease the displayed frequency manually.
When the desired frequency is reached, release the button. The unit
remains in manual tune mode for 3 seconds after either button is released
so you can fine tune the station frequency with additional button presses.
Note: After 3 seconds, seek mode is re-enabled.
H. Scan Functions
Select any AM or FM band and press scan button (11) to listen to a few
seconds of each radio station. The display will flash and the radio will
automatically scan to the next higher station, play that station for a few
seconds, then scan to the next higher station. To stop scanning and con-
tinue listening to the current station, press scan button a second time.
Note: the radio remains in scan mode until the scan button is pressed a
second time or one of the tune buttons is pressed.
I. Preset Scan Function
Press the auto button (16) once to enter scan mode. The next higher pre-
set station will be selected and be played for 3 seconds while the preset
number on the display flashes. If you wish to remain on this station, press
the auto button (16) a second time. Note: preset scanning continues
unless you press the auto button (16) or either preset button (P1-P6) to
cancel.
J. Local/Distance Function
Press the local button (10) to toggle between local and distant station
mode. When “LOCAL” is displayed, only the strongest stations will be
selected during seek or scan. Note: in the default mode (no LOCAL dis-
play), all usable stations will be selected during seek or scan.
K. Changing Tuner Frequency from US to Europe
Your unit is factory set to US tuning frequency steps. To switch to Europe
tuning steps, use the switch on the bottom of the unit. With the unit dis-
connected from the power source, use a screwdriver to slide the switch to
the desired position. Note: power must be removed from the radio, or
the reset switch must be pressed before the new frequency mode is
activated.