Sharp AR-651 - Manual (Page 99)

1
2
3
4
5
6
7
8
9
10
11
12
5-9
4 After selecting the paper type corresponding to the
type of the paper that has been set, press the SET
key.
- When selecting OHP film, the hole punch mode and the
staple mode cannot be used.
3 If the paper other than standard type has been set,
press the PROGRAM key to enter the program menu,
and press BYPASS FEED key.
- If the standard size paper has been set, you do not have to
perform steps 3 to 4.
2 Place the original(s). Page 2-9
If you select the paper type not corresponding to the type of
the paper that has been set, it may cause a problem such as
a paper jam, significant image deterioration, etc.
Select other copy modes as required.
- If you press the MEDIA TYPE key on the right menu, which
is displayed when placing paper on the bypass guide, the
menu of step 4 is also displayed.
5 Press the START key.