Star Micronics LC-6211 - Manual (Page 10)

4 Printer Setup
Installing the platen knob
The platen knob is packed into a recess in the packaging material.
❏
Install the knob on the shaft located inside the large hole on the right side of
the printer. Make sure that the flat side of the shaft is aligned with the
corresponding flat surface inside the knob’s spindle. Press the knob
carefully but firmly into place as far as it will go.
Opening the front cover
❏
Hook your fingers under the two small tabs on either side of the front cover
and pull forward and up to swing the front cover open.
Front cover