Woodstock SHOP FOX W1730 - Manual (Page 28)

-26-
SERVICE
W1730 Oscillating Edge Sander
SERVICE
This section covers the most common service adjustments
or procedures that may need to be made during the life
of your machine.
If you require additional machine service not covered
in this section, please contact Woodstock International
Technical Support for additional guidance at (360) 734-
3482 or send e-mail to: [email protected].
General
MAKE SURE that your machine is
unplugged during all service proce-
dures! If this warning is ignored, seri-
ous personal injury may occur.
In order to maintain accuracy and precision with the oscil-
lating edge sander, periodically calibrate the angle gauge.
To calibrate the angle gauge, do these steps:
1. Loosen the angle adjustment lock handle.
2. Place the machinist's square on the table and press
it against the platen.
3. Adjust the platen until it is flush with the
machinist's square as in Figure 37.
4. Tighten the angle adjustment lock handle.
5. Loosen the angle indicator pin screw, shown in
Figure 38, a 1/2 turn.
6. Align the angle indicator pin with the 90˚ mark and
tighten the angle indicator pin screw.
Calibrating Angle Gauge
Figure 37. Aligning table to platen.
Figure 38. Angle indicator pin screw.