Woodstock SHOP FOX W1730 - Manual (Page 12)

-10-
SETUP
W1730 Oscillating Edge Sander
SEEK assistance when lifting the
machine from the shipping box . The
Model W1730 weighs 396 lbs.
The SHOP FOX ® Model W1730 has been carefully pack-
aged for safe transporting. If you notice the machine has
been damaged, please contact Woodstock International
Technical Support at 1-360-734-3482 or send e-mail to:
[email protected]
UNPLUG the power cord before you
do any assembly or adjustment tasks!
Otherwise, serious personal injury to
you or others may occur!
READ and understand this entire instruc-
tion manual before using this machine.
Serious personal injury may occur if
safety and operational information is not
understood and followed. DO NOT risk
your safety by not reading!
Unpacking
SET UP
The following items are needed, but not included, to
setup your machine:
Description
• Phillips Screwdriver .......................................1
• Straight Slot Screwdriver .................................1
• Machinist's Square .........................................1
• Hammer .....................................................1
• Socket 7/8" .................................................1
• Ratchet w/6" extension ..................................1
• Hex Wrench 4mm ..........................................1
• Dust Collector ..............................................1
• Dust Hoses 4" ...............................................2
• Hose Clamps 4" ............................................4
Items Needed for Set Up