Sharp CV-P09LX - Manual (Page 20)

1 Remove the battery cover at the
back of the remote control.
2 Insert batteries into the compart-
ment, making sure the ±
± ± ± ± and
— — — — — polarities are correctly
aligned.
• Lines will appear on the display
when batteries are properly in-
stalled.
3
Reattach the battery cover.
4 Press the RESET button using a
thin pointed implement.
E-18
NOTES:
• The battery should last approximately one year under normal use.
• When replacing the batteries, always change both batteries at the same time, and
make sure they are the same type.
• If the remote control does not operate normally after replacing the batteries, press
the RESET button using a thin pointed implement.
• If you will not be using the unit for a prolonged period, remove the batteries from
the remote control.
LOADING BATTERIES
Use two AAA (R03) batteries.
Battery cover
PRE-OPERATION CHECKS
RESET
POWER PLUG CHECK
This air conditioner uses a fused power plug.
Always check the power plug before use.
1 Press the RESET button.
2 Insert the power plug into the wall socket.
3 Press the TEST button.
You will hear a CLICK if the circuit breaker is
functioning correctly.
4 Press the RESET button until you hear another
CLICK.
The circuit breaker is activated, power is supplied,
and the air conditioner is now ready for use.
Do not attempt to use the air conditioner if the above procedure is
impossible, as it is malfunctioning.
Disconnect the power plug and request service.
TEST