SATO M10e User Manual
Page 55
![background image](/manuals/139094/55/background.png)
Section 4. Cleaning and Maintenance
SATO M10e
PN 9001101 Rev. A
Page 4-5
CLEANING THE AUTO LOAD SENSOR
In addition, there is one more sensor to sense when the media is correctly positioned for auto
loading. When dust, dirt, adhesive or other foreign matter interferes with the light path of this
sensors, the results is erratic paper end error signals. This sensors should be cleaned regularly,
at least every two rolls of labels.
Supplies Needed:
SATO SA070 Cleaning Kit
1. Turn the printer off.
2. Open the Top Cover.
3. Release the Print Head by pulling
forward on the Head Release Latch
4. Remove the ribbon (M10eTT only)
5. Apply SATO Thermal Print Head
Cleaner to one of the cotton swabs.
6. The sensor is located in the Print Head
Assembly.
7. Use the cotton swab to clean any
foreign matter from the exposed
surface of the sensors.
Label Cover Plate
TBA
Sensor
Print Head