SATO M10e - Manual (Page 29)

Section 3. Configuration
SATO M10e PN 9001101 Rev. A Page 3-7
DEFAULT SETTINGS
SWITCH SELECTIONS
All switches are placed in the Off default position for shipping. This will result in the
following operating configuration:
SOFTWARE DEFAULT SETTINGS
The printer stores the software settings upon receipt and uses them until they are again
changed by receipt of a command containing a new setting. These settings are stored in non-
volatile memory and are not affected by powering the printer off. The printer may be reset to
use the default software settings by depressing the LINE and FEED keys simultaneously while
powering the printer on. This will result in the following default configuration:
Once the default operation is completed, a DEFAULT COMPLETED message will be
displayed on the LCD panel. The printer should be powered off while this message is being
displayed (or after the beep is heard. This saves the default settings in the non-volatile memory
where they will be automatically loaded the next time the printer is powered on.
Communications: 8 data bits, no parity, 1 Stop bit, 9600 Baud
Protocol: Ready/Busy
Sensor: Gap Sensor
Receive Buffer: Multi Job
Mode: Batch/continuous
Label Sensor: Sensor Used
Backfeed: Enabled
External Signals: Enabled
M10e
Print Darkness 3
Print Speed 4 in. per sec.
Print Reference Vertical = 0000, Horizontal = 0000
Zero Slash
Auto On Line Enabled
Feed on Error Enabled
Feed Reprint Enabled
Priority Command
DEFAULT COMPLETED