SATO M10e User Manual
Page 40
Section 3. Configuration
Page 3-18
PN 9001101 Rev. A
SATO M10e
CARD->MEMORY
COPY COPYING
3. Press the ENTER key to accept the selection. If Yes was
selected the copy process will start
CARD->MEMORYCOPY
COMPLETED
4. Once the copy process is completed, press the ENTER key
to step the display.
CARD COPY/FORMAT
XXXXXXX ERROR
5. If an error is encountered in the copy process, one of the
following messages will be displayed on the second line:
R/W Error
Indicates a Read/Write error occured
No Card Error
Indicates no card was recognized
Mem Full Error Indicates that there is insufficient memory
available.
MEMORY->CARDCOPY
ALL
<0MB>
Y/N
This selection allows you to copy the entire contents of the
optional Expanded Memory to the PCMCIA Memory card
installed in the Memory Card slot on the rear of the printer.
1. Use the Cursor keys to step the cursor to desired setting. If
Yes is selected, the printer will enter the Card Copy mode. If
No is selected, the display will advance to the Card to
Memory Copy All mode.
COPY START
YES
NO
2. Confirm your selection by stepping the cursor to the Yes
selection. If you select No, the display will return to the
previous selection.
MEMORY->CARDCOPY
COPYING
3. Press the ENTER key to accept the selection. If Yes was
selected the copy process will start
MEMORY->CARDCOPY
COMPLETED
4. Once the copy process is completed, press the ENTER key
to step the display.
CARD COPY/FORMAT
XXXXXXX ERROR
5. If an error is encountered in the copy process, one of the
following messages will be displayed on the second line:
R/W Error
Indicates a Read/Write error occured
No Card Error
Indicates no card was recognized
Mem Full Error Indicates that there is insufficient memory
available.
CARD->MEMORYCOPY
PROGRAM
Y/N
This selection allows the user to copy printer firmware from the
PCMCIA Memory Card to the printer.
1. Use the Cursor keys to step the cursor to desired setting. If
Yes is selected, the printer will enter the Card Copy mode. If
No is selected, the display will advance to the mode display.
COPY START
YES
NO
2. Confirm your selection by stepping the cursor to the Yes
selection. If you select No, the display will return to the
previous selection.