SATO M10e - Manual (Page 19)

Section 2. Installation
SATO M10e PN 9001101 Rev. A Page 2-7
LABEL SENSING
The M10e can position labels using either a label gap (transmissive) or an Eye-Mark
(reflective) sensor. The sensor used is selected by DSW2-2. The sensor position are fixed and
cannot be adjusted. In addition, the signals from the sensors can be adjusted using the LCD
panel to compensate for different liner opacities and/or Eye-Mark reflectance values.
Platen Roller
Cut Position
Print Position
Auto Load Sensor
Feed Roller
Label Sensor
Eye Mark Sensor
Label Gap Sensor
Paper End Sensor
Auto Load Sensor
Label Feed Direction
All dimensions are in mm