Sharp VL-NZ100S - Manual (Page 79)

Appendix
68
Appendix
Picture/Backlight
Adjustments
Available modes:
All modes
If the picture is difficult to see due to ambient
light or other factors, adjust the monitor picture
settings.
• The example screens shown are for TAPE-
CAMERA mode.
Adjusting the Picture
1
Press the MENU button until the menu
screen appears.
2
Press l or m on the operation button
to select O, then press the SET button.
3
Press l or m to select “LCD BRIGHT”
or “LCD COLOUR”, then press the SET
button.
4
Press l or m to adjust the item to the
desired setting.
5
Press the SET button, then press the
MENU button to turn off the menu
screen.
Note:
• When adjusting the colour, the picture on the
LCD monitor may differ from the picture actually
recorded. Do not change the colour setting
unless necessary. (This adjustment only affects
the monitor picture, not the recorded image.)
Adjusting the Backlight
1
Press the MENU button until the menu
screen appears.
2
Press l or m on the operation button
to select O, then press the SET button.
3
Press l or m to select “BACKLIGHT”,
then press the SET button.
4
Press l or m to select “AUTO”,
“NORMAL”, “BRIGHT” or “OFF”, then
press the SET button.
AUTO: The camcorder automatically
switches between “NORMAL” and
“BRIGHT” depending on the ambient
light. This mode is only available in
TAPE-CAMERA or CARD-CAMERA
mode.
NORMAL: For use indoors or under
moderate lighting conditions.
BRIGHT: For use outdoors under
strong lighting conditions, such as
bright daylight.
OFF: The backlight turns off. To turn it
on again, press the MENU button.
5
Press the MENU button to turn off the
menu screen.
L C D S E T
B A C K L I G H T
L C D B R I G H T
L C D C O L O U R
R E T U RN
A U T O
L C D S E T
B A C K L I G H T
L C D B R I G H T
L C D C O L O U R
R E T U RN A U T O
N O RMA L
B R I G H T
O F F
B ACKL I GHT BR I GHT
LCD BR I GHT
LCD COL OUR
Decrease
Darker Brighter
Increase
VL-NZ100H-068-073 02.2.14, 10:04 AM 68