Sirius Satellite Radio SDST5V1 - Manual (Page 38)

38
or controls . Secure the excess cable with wire ties (purchased
separately) .
4 . Bring the end of the cable out at the PowerConnect Vehicle Dock
location . Leave yourself enough cable so you can easily connect it
to the antenna connector of the dock .
5 . Continue with “Step 5: Connect the Magnetic Mount Antenna and
PowerConnect Power Adapter” on page 41 .
• Convertible:
1 . Bring the antenna cable from the antenna into the trunk at the front
edge of the trunk lid . Keep any bends in the cable loose . Tape or tie
the cable along the inside of the trunk lid to the trunk lid hinge strut .
2 . Allow enough slack in the cable so the trunk lid can easily open and
close and keep the cable away from hinges, gears, etc ., that could
crimp or cut it . Route the cable along the trunk wall and into the
cabin through a conduit or along an existing wiring harness .
3 . Route the cable through the
main cabin area under the
interior trim, towards the front
of the vehicle . Use a blunt
plastic putty knife or similar
blunt tool to lift the plastic
trim just enough to tuck the
cable under underneath . Avoid
side airbag locations on back
pillars and above the doors .
Vehicle Installation