Sharp Aquos LC 46BD80UN - Manual (Page 36)

34
Blu-ray disc Ecology
You can control the power on/off status of the Disc
Drive when power to the TV is on.
Enable: Power to Disc Drive is turned on when a disc is
inserted or when the input source is switched to Blu-
ray.
Disable: Power to Disc Drive is turned on when TV
power is turned on.
No Signal Off
When set to "Enable", the power will automatically shut
down if there is no signal for 15 minutes.
When it is 5 minutes before the power shuts down, the
remaining time will start to keep appearing every minute.
"Disable" is the factory preset value.
When a TV program fi nishes, this function may not operate.
No Operation Off
When set to "Enable", the power will automatically shut
down if there is no operation for 3 hours.
When it is 5 minutes before the power shuts down, the
remaining time will start to keep appearing every minute.
"Disable" is the factory preset value.
•
•
•
•
•
On-Screen Display Menu
Power Control Menu
Power control setting allows you to save energy.
Power Saving [Off]
No Signal Off [Disable]
No Operation Off [Disable]
Blu-ray disc Ecology [Enable]
Power Control
Example
1
Press MENU to display the MENU screen, and then
press c/d to select "Power Control".
2
Press a/b to select a specifi c adjustment item,
and then press ENTER.
3
Press a/b (or c/d) to select the desired setting,
and then press ENTER.
4
Press MENU to exit.
Power Saving
This function allows you to set the Power Saving level
in order to decrease the power consumption and
increase the backlight lifespan.
Standard: Optimizes power reduction based upon video
content. When set to "Standard", " " appears on the
screen.
Advanced: Optimizes power reduction based upon video
content and engages OPC. When set to "Advanced",
"
" appears on the screen.
Off: This function does not work.
"Power Saving" does not function when you set "AV
MODE" to "DYNAMIC (Fixed)".
You cannot select a different Power Saving item for each
AV MODE.
When “Power Saving” is set, the “OPC” settings for all AV
Modes will automatically change.
—If you set “OPC” to “On” when “Power Saving” is set
to “Standard”, then the “Power Saving” setting will
change to “Advanced”.
—When you change the “Power Saving” setting from
“Advanced” to “Off” or to “Standard”, “OPC” will be set
to “Off”.
—“DYNAMIC (Fixed)” will remain set to “Off”.
When "Power Saving" is set to "Standard" or "Advanced",
the Power Saving leaf icon appears to the left of "OPC" in
the Picture menu screen.
You can select Power Saving by pressing
POWER
SAVING on the remote control unit. (See page 18.)
•
•
•
•