Studer Innotec XPC 1112 - Manual (Page 22)

STUDER INNOTEC XP-COMPACT
User manual XP-COMPACT V2.0 E 21
9 Technical Data
Model XPC1112 XPC1624 XPC1648
Inverter
Nominal battery voltage 12 V 24 V 48 V
Input voltage range 9.5 – 17 V 19 – 34 V 38 – 68 V
Nominal power 1100 W 1600 W 1600 W
Maximum power load 30 min. P30 1400 W 2200 W 2000 W
Maximum power load 5 sec 3 x Pnom
Maximum load up to short circuit
Maximum asymmetric load up to Pnom
Standby adjustment 1 to 25 W
Cos ϕ 0.1 - 1
Maximum efficiency 94 % 95 % 95 %
Consumption OFF/Standby/ON 0.5 / 0.6 / 4 W 0.8 / 0.9 / 7 W 1.2 / 1.3 / 7 W
Output voltage 230 Vac (- 10% / 0)
Output frequency crystal controlled 50 Hz ± 0.05 %
Total harmonic distortion < 4% < 2%
Dynamic behaviour on load change 0 → 100 % 0.5 ms
Overload and short circuit protection Automatic disconnection with 3 time restart attempt
Overheat protection Acoustic warning before shut-off - with automatic restart
Battery charger (4 STEP) I-U-Uo-Equalize (every 25 cycles)
Charging current adjustable 0 – 45 A 0 – 37 A 0 – 20 A
Maximum input voltage 265 Vac
Minimum input voltage Adjustable threshold from 150 to 230 Vac
Input frequency 45 – 65 Hz
Power Factor Correction (PFC) EN 61000-3-2
Optional solar charger (4 stages)
Maximum PV open circuit voltage (V) 25 V 45 V 90 V
Maximum charge current (A) 30 A 30 A 20 A
Working principle: I-U-Uo-Equalize (every 25 cycles) Shunt Shunt Shunt
Battery control (thresholds and times adjustable by the user, only with RCC-01)
Absorption time 0-4 h
End charge cycle voltage 14.4 V 28.8 V 57.6 V
Floating voltage 13.6 V 27.2 V 54.4 V
Equalisation voltage 15.6 V 31.2 V 62.4 V
Deep-discharge protection 10.8 V 21.6 V 43.2 V
Temperature compensation (optional CT-35) -3mV / °C / cell
General data
Multifunction contact - potential free (3 points) 16 A – 250 Vac
Max. current on transfer relay 16A / 3.5 kVA 16A / 3.5 kVA 16A / 3.5 kVA
Transfer time < 20 ms
Weight 11.7 kg 12.6 kg 12.6 kg
Dimension h x l x L [mm] 124 / 215 / 410 124 / 215 / 410 124 / 215 / 410
IP protection index IP 20 / IP 23 with top cover
EEC conformity
EN50081 I/II, EN 55014 – EN 55022, EN 61000-3-2
IEC 801 I/II/III/IV, IEC 1000-3-2, LVD 73/23/EEC
Working range -20 to 55°C
Ventilation from 45°C
Acoustic level without / with ventilation < 10 dB / < 35 dB
Warranty 2 years
Options
Solar charger XPC-xxxx-S
Remote control (112 x138 x 25mm / 20 m cable) RCC-01
IP-23 top cover C- IP23
AC cable cover CFC-01
Battery temperature sensor
(58 x 51.5x 22mm / 3 m cable) CT-35
Data may change without any notice