Source Technologies ST9530 User Manual

Page 52

Secure MICR Printer User’s Guide

September 2005

characters.

software, it must be
eight characters long.

MICR Password Error

Password Match
Error

Password sent does
not match the
current stored
password.

Check the Password
Command in your
software.

Password Not Enabled Error

A secure command
was sent without the
password being sent
first

Check software to
ensure that password
is sent before any
secure commands

Invalid AES/DES key

Invalid hex digit or
length of decryption
key

Check syntax of
SETAESKEY or
SETDESKEY
command

Purge Audit Report, Then
Format

An SFF command
was received, but
there is audit data in
flash which should
not be erased

Purge the audit data,
then resend the SFF
command

File System Error Can’t Open
File

There was an
internal error while
trying to access
flash for audit trail

Check that Flash is
installed and not full

Can’t Create Node

There was
insufficient memory
to track another
audit job

Turn printer off and
back on, then retry. If
the problem recurs,
call Tech Support

Secure File Not
Unlocked/Opened/Written/Read

There was an
internal error while
trying to access
Flash for an STL or
STP command

Print the menus to
ensure that Flash is
installed. Print a
directory of Flash to
ensure that is it not
write protected or full.
If error occurs on
STP command,
check to confirm that
the resource is stored
in Flash.