Supervisor password, 34 bios setup – SOYO 6KB82440 User Manual
Page 38
34
BIOS Setup
Supervisor Password
Based on the setting you made in the ÒSecurity OptionÓ of the ÒBIOS
FEATURES SETUPÓ, this Main Menu item lets you configure the
system so that a password is required every time the system boots or an
attempt is made to enter the Setup program. Change the password as
follows:
1. Choose ÒSUPERVISOR PASSWORDÓ in the Main Menu and press
ÒEnter Password:Ó
2. Enter a password and press
(If you do not wish to use the password function, you can just press
3. After you enter your password, the following message appears
prompting you to confirm the new password:
ÒConfirm Password:Ó
4. Re-enter your password and then Press
Menu.
5. You have the right to change any changeable settings in the ÒCMOS
SETUP UTILITY.Ó
Important: If you forget or lose the password, the only way to access the
system is to set jumper JP5 to clear the CMOS RAM. All
setup information is lost and you must run the BIOS setup
program again.