SOYO 6KB82440 - Manual (Page 14)

10 Hardware Setup
IDE1/IDE2 – On-board Primary/Secondary IDE HDD
Connectors
Attach on-board hard disk drives to these connectors.
COM1/COM2 Connectors
Connect COM1/COM2 devices to these connectors.
IDE LED – IDE HDD LED Connectors
Attach on-board IDE device LEDs to this connector. The LED lights
when an IDE device is active.
FDC Connector
Attach floppy cable to this connector.
PRT – Parallel Port Connector
Attach parallel port cable to this connector.
USB1/USB2 – Universal Serial Bus Connector
Attach USB cable to these connectors for external USB device.
PWRBT – ATX Power Supply On/Off Switch Connector
(Momentary Type)
Attach a two-pin switch to this connector for turning the ATX power
supply on/off.