Samsung SP-R6100 - Manual (Page 28)

55
System
54
System
9. Enter 9234, the Authentication Code, which is preset at
factory, then press the OK soft key.
10. When the registration is properly completed, the handset
returns to the Standby mode and displays the base
number and the handset number.
11.Unplug the power cord and then plug it in again.
N o t e s:
• If you have re g i s t e red the handset to several bases, and the
base number you select at step 7 is already used for
another base, you will be asked to confirm that you want to
o v e rwrite. If you press the Ye s soft key, the old inform a t i o n
is cleared and the base number will be used for your newly
selected base. To keep old information, press and hold the
key to cancel the setting, then start over again with a
d i ff e rent base number.
• The time limit for registering a handset to a base is 60
seconds. The registration will be automatically cancelled
when this time has elapsed.
• If you fail to register the handset, the handset displays
Fail to Register.
The handset supplied with the base unit is already registered
as handset 1. Each additional handset you purchase must be
registered to the base unit.
1. Press and hold the Paging key on the base for more than 3
seconds. The light is blinking.
2. Press the Menu soft key on the handset.
3. Press the soft key repeatedly until System appears,
then press the Select soft key. You are asked to enter the
PIN code. It is preset to 0000.
4. Enter the PIN code, then press the OK soft key.
5. Press the soft key repeatedly until Registration
appears.
6. Press the Select soft key. The available bases are
displayed. The selected base to which your handset is
registered has a check mark on its right side.
7. Select a base by using the soft key, then press the
Select soft key. Please wait appears for a short time,
then the LCD window displays the ID of the base unit.
8. Press the OK soft key.
Registering a New Handset
(Menu 6-2)