SIIG UltraATA 100 Pro - Manual (Page 15)

User's Manual
2-4
2-3 Software Installation
This section provides information on how to install the UltraATA
133/100 Pro driver in your Power Mac. Please refer to the Mac OS
manual to familiarize yourself with Drive Setup and OS
Installation routines.
2-3.1 Driver Installation for Mac OS 8.6
For a fresh OS 8.6 installation:
1. Install the UltraATA 133/100 Pro and attached drives.
2. Boot up your computer with the Mac OS 8.6 CD-ROM. Press
and hold letter C on the keyboard while your system is
booting to boot from CD-ROM.
3. When Mac OS finishes booting, double click Utilities folder.
4. Double click Drive Setup icon.
5. Highlight the drive connected to the UltraATA 133/100 Pro
and click Initialize. Be aware that, initializing the drive will
erase all information on this hard disk drive.
6. Close Drive Setup when finished.
7. Double click Mac OS 8.6 CD-ROM, then double click Install
Mac OS 8.6 icon. Follow on-screen instructions to complete
installation.
For systems that have OS 8.6 installed:
1. Install the UltraATA 133/100 Pro and attached drives.
2. Boot up your system. When Mac OS finishes booting, double
click Mac OS 8.6 drive icon on the desktop.
3. Double click Utilities folder.
4. Double click Drive Setup icon.
5. Highlight the drive connected to the UltraATA 133/100 Pro
and click Initialize.
6. Close the Drive Setup screen when finished. The new drive
should appear as Untitled on the desktop.