SIIG UltraATA 100 Pro - Manual (Page 13)

User's Manual
2-2
Note: Hold the board by its external edges only. Try to avoid
touching the components, connectors or pins.
2-2 Device Connection
The UltraATA 133/100 Pro is a dual channel Ultra ATA/133
controller that supports up to four IDE hard disk drives or CD-R/
RW drive. If you plan to use the second IDE channel (IDE2), you
will need to purchase another 40-pin/80-wire Ultra ATA ribbon
cable.
In order to achieve high-speed data transfer, a 40-pin/80-wire
Ultra ATA ribbon cable is recommended. Also, do not mix Ultra
ATA/133 hard disk with slower CD-R/RW drive on the same IDE
channel.
1. Install hard disk drive(s) in chassis.
Figure 2-1: Installing the board