Silvercrest KH2217 - Manual (Page 17)

- 17 -
Snooze function
With the button
SNOOZE/ DISPLAY DIMMER you can interrupt the alarm
function for a period of between 1 and 30 minutes, this period being
programmed by yourself (see next section). The factory setting is
9 minutes.
On the expiration of this period the alarm tone or radio sounds again
(Automatic after-call). The function can be repeated up to six times. After
that, the alarm first sounds on the following day.
The automatic after-call allows itself to be individually adjusted to
between 1 and 30 minutes. The radio is switched off and the automatic
after-call is not active.
1. Press and hold the button
SNOOZE/DISPLAY DIMMER until SNO and the
minute indication appears on the display.
2. Press the button MIN+ SET to programme the minutes.
3. As soon as the desired after-call period is displayed, release the
button.
4. Press the button SNOOZE/DISPLAY DIMMER .
The programmed after-call period is taken over.
Note:
Should a second alarm time be pending during an activated snooze
function, the second alarm time will eventually switch itself on and, if need
be, the snooze function must once again be reactivated.
Adjusting the display brightness
Mains power operation:
1. Press the button
SNOOZE/DISPLAY DIMMER at intervals of 2 seconds.
The display brightness changes itself as follows:
Bright>Medium>Dark>Bright
IB_KH2217_AR23896_LB6 24.09.2008 15:33 Uhr Seite 17