SUPER MICRO Computer Dual Processor AS 1020C-3 - Manual (Page 54)

5-20
AS1020C-3 User's Manual
I 2 C to PCI Enable/Disable
The JI 2 C1/2 pair of jumpers allows you
to connect the System Management
Bus to any one of the PCI expansion
slots. The default setting is closed (on)
for both jumpers to enable the connec-
tion. Both connectors must be set the
same (JI 2 C1 is for data and JI 2 C2 is for
the clock). See the table on right for
jumper settings
I 2 C to PCI Enable/Disable
Jumper Settings
(JI 2 C1/2)
Jumper Setting Defi nition
Closed Enabled
Open Disabled
3rd Power Supply Fail Signal
Enable/Disable
The system can notify you in the event
of a power supply failure. This feature
assumes that three redundant power
supply units are installed in the chas-
sis. If you only have one or two power
supplies installed, you should disable
the function with the J3P header to pre-
vent false alarms. See the table on the
right for jumper settings.
3rd Power Supply Fail Signal
Jumper Settings (J3P)
Jumper Setting Defi nition
Open Disabled
Closed Enabled
Compact Flash Master/Slave
The JCF1 jumper allows you to assign
either master or slave status to an
installed compact fl ash card. See the
table on the right for jumper settings.
Compact Flash
Master/Slave
Jumper Settings (JCF1)
Jumper Setting Defi nition
Closed Master
Open Slave
VGA Enable/Disable
JPG1 allows you to enable or disable
the VGA port. The default position is
on pins 1 and 2 to enable VGA. See
the table on the right for jumper set-
tings.
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled