SUPER MICRO Computer Dual Processor AS 1020C-3 - Manual (Page 3)

Preface
About This Manual
This manual is written for professional system integrators and PC technicians. It
provides information for the installation and use of the A+ Server 1020C-3. Instal-
lation and maintainance should be performed by experienced technicians only.
The 1020C-3 is a high-end 1U rackmount server based on the SC813T+-500 server
chassis and the H8DCR-3 serverboard, which supports dual AMD Opteron™ 200
series processors and up to 32 GB of registered ECC DDR333/266 or up to 16 GB
of registered ECC DDR400 SDRAM.
Manual Organization
Chapter 1: Introduction
The fi rst chapter provides a checklist of the main components included with the
server system and describes the main features of the H8DCR-3 serverboard and
the SC813T+-500 chassis, which make up the 1020C-3.
Chapter 2: Server Installation
This chapter describes the steps necessary to install the 1020C-3 into a rack and
check out the server confi guration prior to powering up the system. If your server
was ordered without processor and memory components, this chapter will refer you
to the appropriate sections of the manual for their installation.
Chapter 3: System Interface
Refer here for details on the system interface, which includes the functions and
information provided by the control panel on the chassis as well as other LEDs
located throughout the system.
iii
Preface