Sanyo CCA-BC200 - Manual (Page 13)

12
INSTALLATION
Installing system on rear spoiler
1. Clean the location where the camera is to be installed.
Wipe off oil, wax, moisture, dirt and dust using a
cleaner and a clean cloth.
2. Peel off the paper backing from the tape on the camera
bracket and firmly attach the bracket to a flat surface on
the rear spoiler.
Press the bracket with a finger to assure good contact of
the bracket to the surface of the vehicle. Touching the
sticky surface of the tape with a finger or re-adhering the
bracket will weaken the adhesion strength and result in a
loose installation that could eventually fall off.
•
If the temperature where the camera bracket is to be installed is low, warm the area with a hair
dryer so that the tape adheres firmly to the surface. Do not apply heat to the camera or the lens.
3. Install the camera to the bracket using the screws.
Install the camera (SANYO logo facing upward)
using the hexagon wrench included in the product
package.
Bracket
• Mount the camera level with the
vehicle and ground surface.
CAUTION
• Position the lens axis of the camera
square to the vehicle in order to
obtain a correct rear view.
OK NG
NG OK
Bracket
Camera mounting screw
Camera
Need help? Call
1-800-421-5013