Seiko Group TM-L60 - Manual (Page 13)

2-2 Connecting the Host Computer to the Printer
n Connecting the interface cable
Connect the printer to a host ECR (host computer) using an interface cable
matching the specifications of the printer and the host ECR (host computer).
Connect the interface cable according to the following procedure.
Turn off the printer, power unit, and host computer.
Plug the interface cable connector into the interface connector on the printer;
then insert a screwdriver between the rear rubber feet and fasten the screws on
both sides of the connector.
Plug the drawer kick-out cable connector into the drawer kick-out connector on
the printer (if this connector is covered, you cannot attach a drawer kick-out
cable to your printer).
•
Remove the drawer kick-out cable by pressing in on the connector’s clip and
pulling out.
Serial Interface Cable
Drawer Kick-out Connector
7