Southbend 4365A - Manual (Page 16)

I NSTALLATION U LTIMATE R ESTAURANT R ANGES
P AGE 16 OF 48 O WNER ’ S M ANUAL 1190820 REV 3 (11/10)
S TEP 2 A : A TTACH L EGS
A set of four legs is packed with ranges ordered with legs. (For ranges ordered with casters, go to Step 2b.)
A threaded leg pad is fastened to the base frame at each corner. Each leg has a corresponding mating thread. The
legs can be adjusted to overcome a slightly uneven floor.
1. Raise range sufficiently to allow legs to be attached. For safety, “shore up” and support the range with an
adequate blocking arrangement strong enough to support the load.
2. Screw the legs into the holes in the centers of the leg pads. The legs should be fully screwed into the leg pads.
3. Lower range gently onto a level surface. Never drop or allow the range to fall.
4. Use a level to make sure that the range surface is level. The foot of each leg can be screwed in or out to lower or
raise each corner of the range.
5. Go on to Installation Step 3.
Figure 3
Installation of Legs