Sony STR-DG1100 - Manual (Page 44)

44 GB
• Frequency Characteristic
6
Press b.
7
Press to select “Start.”
8
The measurement starts in five
seconds.
9
Measurement starts.
The measurement process will take
approximately 30 seconds with a test
tone. Wait until the measurement process
completes.
Note
You cannot measure the speaker height of the
surround speakers and the surround back speakers.
Set the position of the surround speakers from
“Position” in the Speaker settings menu.
Tips
• Operations other than turning the receiver on or off
are deactivated during the measurement.
• When connecting special speakers, such as dipole
speakers, the measurements have not been
performed correctly or auto calibration cannot be
performed.
To cancel the measurement
The measurement is cancelled when you
change the volume, switch functions, change
the setting of the SPEAKERS switch, or
connect headphones.
1
Confirm the measurement
result.
When the measurement ends, a beep
sounds and the measurement result
appears on the TV screen.
Confirming/saving the
measurement results