Sanyo ECD-T1580DV - Manual (Page 35)

TROUBLE SHOOTING
If it appears that your DVD unit is faulty,
first consult this checklist. It may be that
something simple has been overlooked.
Under no circumstances should you
try to repair the player yourself, as this
will invalidate the warranty. Only
qualified service personnel can
remove the cover or service this
player.
NO POWER
Check if the on/off button on the front
of the player is set to on.
Check if AC or DC power plug of the
mains unit is properly connected.
Check if there is power at the AC or
DC outlet.
NO PICTURE
Check if the mode it set to proper
state, such as DVD mode, RADIO,
TV, AV and RGB mode.
Check the video connection.
DISTORTED PICTURE
Check the disc for fingerprints and
clean with soft cloth, wiping from
centre to edge.
Sometimes a small amount of picture
distortion may appear. This is not a
malfunction.
THE PICTURE IS OVER DARK, OVER
BRIGHT OR HAS NO COLOR
Press PICT button on the monitor
panel, then press + button - button
to increase or decrease the level of
the corresponding item (BRIGHT,
CONTRAST, COLOR or TINT) to
proper value, then you can get an
optimum picture effect.
COMPLETELY DISTORTED PICTURE
The disc format is not according to the
TV-set used (PAL/NTSC).
NO COLOR IN PICTURE
The disc format is not according to the
TV-set used (PAL/NTSC).
35
Clean the disc.
Check if the disc is defective by trying
another disc.
NO SOUND
Check audio connections.
If using a HIFI amplifier, try another
sound source.
Check if the volume is minimum, and
adjust the VOL+ to increase the
volume level.
NO RETURN TO START-UP SCREEN
WHEN DISC IS REMOVED
Press POWER to turn off the unit, then
press it again to tur n on the unit.
Press reset button on the front of the
DVD unit.
THE PLAYER DOES NOT RESPOND
TO THE REMOTE CONTROL
Aim the remote control directly at the
sensor on the front of the player.
Avoid all obstacles which may interfere
with the signal path.
Inspect or replace the remote control
batteries.
DISTORTED OR B/W PICTURE
The disc format is not according to the
TV-set used (PAL/NTSC).
NO AUDIO AT DIGITAL OUTPUT
Check the digital connections.
Check the Digital Audio menu to make
sure that the digital output is correctly
set.
Check if the audio format of the
selected audio language matches your
receiver's capabilities.
DISC DOES NOT PLAY
Ensure the disc label is upwards.