beautypg.com

Т³гж 20, Operation – Sanyo ECD-T1580DV User Manual

Page 20

background image

20

OPERATION

Remote Sensor
There is a remote sensor on the front
panel. On the monitor, there is another
remote sensor to receive remote control
signal. You can point the remote control
handset to the remote sensor on the front
panel (when the monitor doesn't stretch
out) or the remote sensor on the monitor
panel (when the monitor stretches out)
and press function keys on the remote
control to control the DVD unit.

The unit is also connected to an external
remote receiver (See the electrical
connection diagram above), and the
function is the same with the remote
sensor on the front panel or on the
monitor panel.
Notes:

The external remote receiver is placed

near the monitor for the best to
reception of the remote signal.

.

If the angle of the monitor from vertical

exceeds

(Especially the distance

exceeds 3m.), controlling the DVD unit
through the remote sensor on the front
panel may not be effective. You are
suggested to use the external remote
receiver.

.

6.5 Inch TFT Display
When the monitor stretches out, the 6.5
inch color TFT display can show the
current state of the unit.

Volume Level Adjustment

Press VOL+/- buttons on the remote
control to increase or decrease the
volume level.

Mode Selection

Press MODE button on the remote
control to select among DVD, RADIO TV,
AV and RGB mode.

Reset

Reset button is placed on the front panel
and must be activated with either a
ballpoint pen or thin metal object. The
reset button is to be activated for the
following reasons:
- Initial installation of the unit when all

wiring is completed.

- All the function buttons do not

operate.

- Error symbol on the display.

Picture mode Adjustment

Press PICT button on the monitor panel,
the picture mode will show on the
display, repeatedly press PICT button to
select among BRIGHT, CONTRAST,
COLOR, TINT (For the unit with NTSC
system) and SCREEN.

Press +/- buttons on the monitor
panel to adjust the selected item. The
corresponding value will show on the
display.

30

(For the unit with NTSC system):

PICTURE

BRIGHT

32

CONTRAST

32

COLOR

32

TINT

32

NOTE (FOR THE UNIT WITH
TEL-MUTE AND BRAKE FUNCTION):
When there is an incoming call, the
unit will be in mute state, and “TEL
MUTE” appears on the screen
display.
If you are driving the car (BRAKE
OFF),

the picture will not be shown on

the screen in DVD/TV/AV mode for
safety purpose. Only the audio will be
heard.

SCREEN

16:9