Т³гж 25, Operation – Sanyo ECD-T1580DV User Manual
Page 25
25
OPERATION
everse,
: Rapid advance
Note: The FOLDER cannot be selected
during playing. It can be selected after
(Stop) button pressed.
: Rapid r
During playback, use
or to skip an
item ahead or back.
same song over and over again.
FOLDER REP:
Play all songs in the current directory in
sequence, over and over again.
When select PLAY MODE, press /
to change between the following mode:
REP-ONE
FOLDER
FOLDER REP
DISC
DISC REP
RANDOM
PROGRAM PXXX
button repeatedly can select three kinds
of repeat play modes.
REP-ONE:
Play the
FOLDER:
Play all songs in the current directory
once.
SINGLE
DISC SCAN
SHUFFLE ON
Switching to radio mode
Press MODE button on remote
control to select radio mode.
In radio mode, the following
information will appear on the display.
Selecting the frequency band
Press BAND on remote control to
select desired band. The reception
band will change in the following
order:
FM1 98.1 MHz
MONO
40
M1
87.50
BASS
-2
M2
90.10
TREBLE
-2
M3
98.10
BALANCE
L-R
M4 106.10
FADER
F-R
M5 108.00
LOUD
OFF
M6
87.50
EQ
POP
RADIO OPERATION
FM1
FM2
FM3
AM1
AM2
VOLUME
Selecting station
During radio mode, press CH button
on remote control to increase
frequency or CH button on remote
control to decrease frequency by one
step of channel spacing. Hold the
button longer for fast tuning. The
frequency is updated correspondingly
on display.
Setting memory
Press RADIO PRESET buttons (1~6)
on remote control to preset stations
at radio mode. With this system, a
total of 30 stations can be stored in
the memory of six buttons. Each
band stores up to six preset stations.
The stations might be FM1, FM2,
FM3, AM1 and AM2 band.
The operation is as below:
- Store in Memory
Press and hold desired
memory location button for
several seconds. The current
listening station will be stored
into the number button.
- Retrieve a Preset Station
Press any one of the RADIO
PRESET buttons (1~6) on
remote control to retrieve a
station which had been stored
in the memory in advance the
chosen number is shown on
display.
Automatic memory storing &
program scanning
- Automatic memory storing
Press GOTO (AS/PS) button
on remote control for several
seconds, the radio searches
from the current frequency and
checks the signal strength until
one cycle search is finished.
And then 6 strongest stations
are stored into the
corresponding preset number
button.
- Program scanning
Press GOTO (AS/PS) button
on remote control shortly to
scan preset station.