Fig-4, Fig-5 – Sanyo LNS-W06 User Manual
Page 4
-3-
4
Remove lens cap on the rear (mounting side) of the projection lens and mount Lens Attachment to the
lens with four screws included with the lens.
Insert the connector at the end of Lens Motor Lead into the socket located at right-top of the lens
attachment. (With motor model only.)
Fig-4
Socket
Lens Motor Lead
Lens Attachment
Connector
Part No. (610 275 6029)
Lens Attachment
POA-LNA-04 (610 317 1289)
Locate motor on
right side.
5
Pinch Lens Lock Lever and turn it clockwise to unlock. (See Fig-5.)
Insert the Lens through the lens mounting bracket and turn the lens lock lever anticlockwise until the lens
is securely mounted. After installing the lens, make sure the Lens is not loose and properly mounted.
(See Fig-6 and Fig-7 on next page.)
Fig-5
Lens Lock Lever
Driver included with
the lens
Note : Lens Illustrations in this manual may differ from the actual product.
Note : Lens attachment is not included in this lens.
Driver included with
the lens
Part No. (610 275 6029)
Lens Attachment