Sony CMT-GPX6 - Manual (Page 28)

28 GB
To save a tape permanently
To prevent a tape from being accidentally recorded
over, break off the cassette tab from side A or B as
illustrated.
If you later want to reuse the tape for recording, cover
the broken tab with adhesive tape.
Before placing a cassette in the tape
deck
Take up any slack in the tape. Otherwise, the tape may
get entangled in the parts of the tape deck and become
damaged.
When using a tape longer than
90 minutes
The tape is very elastic. Do not change the tape
operations such as play, stop, and fast-winding
frequently. The tape may get entangled in the tape
deck.
Cleaning the tape heads
Clean the tape heads after every 10 hours of use. Be
sure to clean the tape heads before you start an
important recording or after playing an old tape. Use a
separately sold dry-type or wet-type cleaning cassette.
For details, refer to the instructions of the cleaning
cassette.
Demagnetizing the tape heads
Demagnetize the tape heads and the metal parts that
have contact with the tape after every 20 to 30 hours of
use with a separately sold demagnetizing cassette. For
details, refer to the instructions of the demagnetizing
cassette.
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
(The United States model only)
With 6 ohm loads, both channels driven, from
120-10,000 Hz; rated 35 watts per channel
minimum RMS power, with no more than 10%
total harmonic distortion from 250 milliwatts to
rated output.
Main unit (HCD-GPX7/HCD-GPX6/HCD-
GPX5)
Amplifier section
HCD-GPX7 for CMT-GPX7
Argentine model:
DIN power output (rated): 40 + 40 W (6 ohms at 1
kHz, DIN)
Continuous RMS power output (reference):
55 + 55 W (6 ohms at 1
kHz, 10% THD)
Music power output (reference):
100 + 100 W
Other models:
DIN power output (rated): 40 + 40 W (6 ohms at 1
kHz, DIN)
Continuous RMS power output (reference):
60 + 60 W (6 ohms at 1
kHz, 10% THD)
Music power output (reference):
100 + 100 W
HCD-GPX6 for CMT-GPX6
North American model:
Continuous RMS power output (reference):
40 + 40 W
(6 ohms at 1 kHz, 10%
THD)
Other models:
The following measured at AC 240 V, AC 220 V or AC
120 V
DIN power output (rated): 30 + 30 W
(6 ohms at 1 kHz, DIN)
Continuous RMS power output (reference):
35 + 35 W
(6 ohms at 1 kHz, 10%
THD)
Break off the
cassette tab
Specifications