JVC CA-MXG950V - Manual (Page 33)

– 29 –
English
On the unit ONLY:
1
Press CLOCK/TIMER repeatedly
until “DAILY” appears on the
display.
indicator lights up and DAILY (Daily
Timer) indicator also starts flashing on the
display.
• Each time you press the button, the timer setting modes
change as follows:
2
Press CLOCK/TIMER again.
“ON TIME” appears for 2 seconds, then the
unit enters on-time setting mode.
3
Set the on-time you want
the unit to turn on at.
1) Turn 4/¢ to set the hour,
then press SET/DISPLAY.
2) Turn
4/¢ to set the
minute, then press SET/
DISPLAY.
“OFF TIME” appears for 2
seconds on the display, then the
unit enters off-time setting
mode.
4
Set the off-time you want the unit to turn off
(on standby) at.
1) Turn
4/¢ to set the hour, then press SET/
DISPLAY.
2) Turn 4/¢ to set the minute, then press SET/
DISPLAY.
The unit enters source selecting mode.
Using the Timers
There are three timers available — Daily Timer, Recording
Timer and Sleep Timer.
Before using the timers, you need to set the clock built in the
unit. (See page 10.)
Using Daily Timer
With Daily Timer, you can wake to your favorite music or
radio program. You can set the timer whether the unit is on or
off.
How Daily Timer works
The unit automatically turns on, sets the volume level to the
preset level, and starts playing the specified source when the
on-time comes (the
indicator flashes just before the on-
time, and continues flashing while the timer is operating).
Then, when the off-time comes (“OFF” flashes just before the
off-time), the unit automatically turns off (on standby).
The Daily timer works everyday automatically. If you do not
want to use the Daily timer, turn off the Daily timer. (See “To
turn on or off Daily Timer after its setting is done” on page
30.) The timer setting remains in memory until you change it.
• There is a time limit in performing the following steps. If
the setting is cancelled before you finish, start from step 1
again.
• To correct a mis-entry while setting the timer, press
CANCEL/DEMO.
Before you start...
• When using a CD as the source to play —
– Make sure there is a CD on the selected disc number
tray.
• When using a tape as the source to play —
– Make sure that a tape is in the deck whose deck
indicator (A or B) is lit on the display.
– Make sure that the tape direction is correct.
• When using an external component as the source to play
—
– Set the timer equipped on the external component at
the same time.
DAILY ON TIME
ON TIME
REC
Clock
setting
(See page 10.)
Cancelled
EN24-35.CA-MXG950/850/750 3/1/02, 3:52 PM 29