JVC CA-MXG950V - Manual (Page 22)

– 18 –
English
Playing Back Video CDs
Selecting Video Output (PAL, MULTI, NTSC)
You can set this setting in Standby mode.
Before playing a VCD, use the buttons on the unit to select a
video output mode to match your TV system.
Video output is preset for PAL.
1
Press and hold one of the disc
number buttons (CD1, CD2 or
CD3) for more than 2 sec.
CD3 ............. for NTSC exclusive TV.
CD2 ............. for Multisystem TV.
Multi detects the formula of the disc
(NTSC/PAL) automatically and displays the
image on the screen correctly.
CD1 ............. for PAL exclusive TV.
Selection of Video Output Mode
• When you play an NTSC disc in MULTI mode on a PAL
exclusive TV, the image may be distorted. If this happens, change
the mode to PAL.
• When you play an NTSC disc in MULTI mode on a Multisystem
TV, the image may blink for a moment. This symptom is caused
by the Unit detecting the formula of the disc, not by a malfunction
of the unit.
• Selection of video output mode works only in standby mode.
Loading Discs
1
Press
0 for the disc tray (CD1, CD2 or CD3)
you want to load a CD onto.
The unit automatically turns on and the disc tray comes
out.
2
Place a disc correctly within the circle of the
disc tray, with its label side up.
• When using a CD single (8 cm), place it within the inner
circle of the disc tray.
3
Press the same
0 you have pressed in step 1.
The disc tray closes, and the corresponding disc number
lamp and disc indicator light up on the display (CD1,
CD2 and CD3).
CORRECT INCORRECT
4
Repeat steps 1 to 3 to place other CDs.
When you place a CD onto the currently selected tray, whose
disc number shown on the CD indicator, reading of the CD
starts. After the reading is completed, the total number of
tracks and total playing time will appear, then the playing
time of the first track.
If the video CD has the Playback Control function, “VCD
PBC” will appear when you press STOP followed by PBC.
To put an 8 cm CD onto a tray, insert it so that it is aligned
with the groove in the trays center.
If a tray is open when the System switches to the standby
mode, the tray will close automatically.
Playing a Video CD
You can play video CDs either with or without the PBC
function.
1
Turn on the TV and select the video input so
that you can view the pictures from the CD
player.
Refer to the manual supplied for your TV.
2
Prepare a CD.
Refer to “Loading Discs” on this page.
3
Start playback of the CD.
Press CD
3¥8 SELECT, to start playback of the currently
selected CD, or press CD 1-3, to select the disc and start
play.
Compu Play
When CD
3¥8 SELECT, or CD 1-3, is pressed while the
system is on standby, the power is automatically turned on.
To stop during play, press 7.
To stop play and remove the disc, press 0 for the disc
being played.
\ \
READING NOW Total number of tracks
and playing time
Playing time of the
1st track
EN14-23.CA-MXG950/850/750 3/1/02, 3:49 PM 18