JVC TH-C7 TH-C6 - Manual (Page 17)

14
Operating external components with the remote control
NOTE
• Manufacturers’ codes are subject to change without notice.
• Set the codes again after replacing the batteries of the remote control.
7 To set the manufacturer’s code
You can operate a JVC TV without setting the manufacturer’s code.
1
Slide the remote control mode selector
to TV.
2
Press and hold TV.
Keep the button pressed until step 4 is finished.
3
Press ENTER.
4
Press number buttons (1-9, 0) to enter
the manufacturer’s code (2 digits).
Examples:
For a Hitachi TV:
Press 1, then 0.
For a Toshiba TV:
Press 0, then 8.
5
Release TV.
If there is more than one code listed for corresponding brand,
try each one until you enter the correct one.
7 Operation
Aim the remote control at the TV.
IMPORTANT
Before using the remote control to operate a TV;
• Set the remote control mode selector to TV.
The following buttons are available:
TV: Turns TV on and off.
TV VOL +/–: Adjusts the volume.
TV/VIDEO: Selects the input mode (either TV or
VIDEO).
CHANNEL +/–: Changes the channels.
1-10, 0, +10 (100+): Selects the channel.
TV RETURN:
Alternates between the previously selected
channel and the current channel.
7 To set the manufacturer’s code
1
Slide the remote control mode selector
to VCR/DBS.
2
Press DBS.
3
Press and hold F VCR/DBS.
Keep the button pressed until step 5 is finished.
4
Press ENTER.
The buttons described below are used on pages 14 and
15.
Operating the TV
TV/VIDEO
REC
VCR
TV
TV VOL CHANNEL
VCR/DBS
DBS
VCR/DBS
TV
ENTER
TV RETURN 100+