JVC HM-DT100U - Manual (Page 73)

Masterpage:Right-FullCol
EN
73
Filename [HM-100U_Eng_05Index.fm]
4
Set Canadian Ratings
• For brief definition on the individual ratings,
refer to ‘Rating Systems’ on page 74.
C Press [MENU] to exit when setup is com-
pleted.
E
Unrated programs
Unrated programs are programs that do not contain a
rating signal. They include emergency bulletins, news,
public service announcements or weathers etc. TV
programs or movies that do not have rating signals will
be blocked if the unrated category is set to “BLOCK”.
First follow steps 1 and 2 on page 71, then go to the
following steps.
3
Access Unrated screen
4
Set blockings
A Press [D E] to select “BLOCK”.
B Press [MENU] to exit.
F
Set lock code
V-Chip settings are protected by a four-digit code. The
default lock code for the VCR is “0000”. You may set the
code to any four-digit number you prefer.
First follow steps 1 and 2 on page 71, then go to the
following steps.
3
Access Set Lock Code screen
4
Set lock code
G
Viewing a blocked channel
When a viewer attempts to watch a blocked channel, the
following message will appear on the screen:
The channel will remain blocked until the correct code is
entered using the ‘Number’ keys on the remote.
NOTES:
• The default lock code is “0000”.
• The lock code being set will return to the default code when
the AC power cord is removed and inserted again, or upon
recovery after power interruption.
In case you forgot the lock code, you can reset it by removing
and inserting the AC power cord.
• Once block has been released, it will remain in this state until
the VCR is power off.
A Press [FG D E]
to move the cur-
sor to the correct
location.
B Press [OK] to turn
on or off the
blocking feature.
OR
Press [FG] to move
the arrow to
“UNRATED”.
THEN PRESS [OK]
SELECT WITH ARROW KEYS
SELECT
OK
EXIT
MENU
CANADIAN RATINGS ENG
DIGITAL SET UP
<18+> <14+>
_ _ _ _ _ X
THEN PRESS [OK]
SELECT WITH ARROW KEYS
SELECT
OK
EXIT
MENU
CANADIAN RATINGS FRE
DIGITAL SET UP
<18+> <16+> <13+> <8+>
_ _ _ _ X
THEN PRESS [OK]
UNRATED
SET LOCK CODE
SELECT WITH ARROW KEYS
SELECT
OK
EXIT
MENU
VIEW
DIGITAL SET UP
DIGITAL PROGRAM CLOSED CAPTION TUNER PARENTAL
Press [FG] to move
the arrow to “SET
LOCK CODE”, then
press [OK].
A Press [FGD E]
to input the num-
ber.
B Press [OK] to set
in the lock code.
C Press [MENU] to
exit.
THEN PRESS [OK]
UNRATED
SET LOCK CODE
SELECT WITH ARROW KEYS
SELECT
OK
EXIT
MENU
VIEW
DIGITAL SET UP
DIGITAL PROGRAM CLOSED CAPTION TUNER PARENTAL
THEN PRESS [OK]
SELECT WITH ARROW KEYS
SELECT
OK
EXIT
MENU
SET LOCK CODE
DIGITAL SET UP
0 0 0 0
THIS PROGRAM EXCEEDS
YOUR RATING LIMITS.
PLEASE ENTER LOCK CODE BY 10 KEY.
HM-DH100U_Eng.book Page 73 Thursday, August 5, 2004 1:54 PM