Remote control functions, Remove power supply, Set remote control code – JVC DD868EU User Manual
Page 33: Re-supply power, Turn the recorder on, Special features, Remote a/b code switching
EN
33
Remote A/B Code Switching
The remote control is capable of controlling two JVC video
recorders independently; one set to respond to the remote
control’s A code control signals and another set to respond to B
code control signals. The remote control is preset to send A
code signals because your video recorder is initially set to
respond to A code signals. You can easily modify your video
recorder to respond to B code signals.
REMOVE POWER SUPPLY
1
Unplug the mains power cord from the mains outlet.
SET REMOTE CONTROL
CODE
2
Press and hold VCR on the remote control for over 2
seconds, press the NUMBER key "2" and then press OK.
RE-SUPPLY POWER
3
Plug the mains power cord back into the mains outlet.
TURN THE RECORDER ON
4
Press
on the remote control. The recorder will now
only respond to B code signals.
NOTE:
To set the recorder back to respond to A code signals, repeat the
same procedure as shown above except pressing NUMBER key
"1" instead of "2" in step 2.
SPECIAL FEATURES
Remote
Control
Functions
1
2
3
4
5
6
7
8
9
1
2
3
4
1
2
3
4
– –:– –
0
VCR
NUMBER "1"
N
U
M
BE
R
"2
"
OK