JVC SR-VS10U - Manual (Page 40)

40
EN
1 2 3
4 5 6
7 8 9
0
2
4
1
3
T W
DV VHS
VCR Plus+ ®
Timer
Programming
Timer recording allows you to program the VCR to automatically
record a program that will be broadcast at some future time.
The timer record function can be programmed using the VCR
Plus+ or Express Timer programming up to 6 shows each on the
VHS and DV decks as far as a year in advance. (
੬
pg. 40 or 44)
The VCR Plus+ timer programming system eliminates the need
to input channel, date, start and stop time data when setting the
timer record function. Simply key in the PlusCode number for
the TV program you wish to record and the VCR's timer will be
automatically programmed. (The PlusCode programming
numbers are the numbers next to the program in most TV listing.)
TIMER RECORDING
LOAD A CASSETTE
1
Insert a VHS (or S-VHS) cassette with the record safety
tab intact, or a Mini DV cassette with the erase
protection switch set to "REC".
● The VCR’s power comes on automatically.
● Select the recording deck by pressing VHS or DV.
ACCESS VCR PLUS+ SCREEN
2
Press PROG. on the
remote control.
● The clock must be set in
order to access the VCR
Plus+ screen. If you
haven’t set the clock, the
Main Menu screen
appears after an error
message is displayed.
Refer to page 8 for the Plug & Play procedure or page
10 for the clock setting procedure.
ENTER PLUSCODE NUMBER
3
Press the appropriate
NUMBER keys to enter the
PlusCode number printed
in the TV listings for the
TV program you wish to
record and press OK.
If the Guide Channel Set
screen appears, go to step 4.
If the VCR Plus+ program
screen appears, go to step 5.
● To make corrections, press CANCEL and input the
correct PlusCode number.
INPUT RECEIVING CHANNEL
NUMBER
4
The Guide Channel
Number, which is assigned
to the TV or cable station
for the PlusCode number
that you entered in step 3,
will appear automatically
on the Guide Channel Set
screen. Input the number
of the channel on which the broadcast for the PlusCode
number is received on the VCR or cable box using the
NUMBER keys, CH
5∞ or %fi, then press OK.
● The Guide Channel Set screen appears only when you
input the PlusCode number of a station for which the
Guide Channel number has not previously been set.
● If you receive your channels with a cable box and if
you have properly set your Controller, "CABLE CH"
appears in place of "VCR CH". If not, refer to pages
15 – 17.
VCR PLUS+
PRESS NUMBER KEY (0–9)
PRESS (+/–) TO SET
EXPRESS PROGRAMMING
PRESS (PROG.) TO END
VCR PLUS+
123
PRESS NUMBER KEY (0–9)
THEN (OK)
PRESS (PROG.) TO END
GUIDE CHANNEL SET
GUIDE CH: 12
VCR CH : – – –
PRESS NUMBER KEY (0–9)
OR ( 5,∞), THEN (OK)
PRESS (PROG.) TO END
NUMBER
CANCEL
PROG.
Turn on the TV and select the AV mode.
CH
OK
DV
VHS
VHS
DV