Access dbs receiver brand set screen, Set dbs receiver brand, Initial settings (cont.) – JVC SR-VS10U User Manual

Page 20

VHS

NUMBER

ACCESS DBS RECEIVER

BRAND SET SCREEN

Press OK.

SET DBS RECEIVER BRAND

Press the appropriate
NUMBER keys to enter the
DBS Receiver Code from
the following list, then
press OK.

● After OK is pressed, the program currently received

through the DBS receiver will appear for about 10
seconds.

● If the DBS receiver's channel changes to the channel

listed below for your brand of DBS receiver, setting is
complete. Press OK and "DBS RECEIVER CONTROL
IS ON" appears on the screen for about 5 seconds,
then it returns to the normal screen.

JVC [ 100
ECHOSTAR [ 100
PRIMESTAR [ 55
SONY [ 205
RCA [ 205

● If the DBS receiver's channel does not change as

shown above, press CH

5∞ or %fi to move the

highlight bar (arrow) to "NO", then press OK. Re-
enter the correct code.

BRAND

CODE

JVC (DISH Network)

ECHOSTAR (DISH Network)

PRIMESTAR

SONY (DSS)

RCA (DSS)

NOTES:

●

It is possible that the Controller will not work with all types of
DBS receiver.

●

If your DBS receiver doesn’t respond to the code, you can’t
use the Controller to change satellite channels. In this case,
make sure to leave the DBS receiver turned on and tuned to
the proper channel before the scheduled start of timer
recording.

●

The VCR can only change the satellite channel through the
Controller during timer recording.

●

If your DBS receiver is one that can’t be operated with a
remote control (because it has no remote sensor), you can’t
use the Controller to change its channels. Make sure to leave
the DBS receiver turned on and tuned to the proper channel
before the scheduled start of timer recording.

●

If you are unable to set the Controller, please contact JVC toll
free at 1-800-252-5722.

DBS RECEIVER BRAND SET

4 0

PRESS NUMBER KEY (0–9)

THEN (OK) TO TEST

PRESS (MENU) TO END

INITIAL SETTINGS (cont.)