JAI TM-6710 - Manual (Page 11)

Page 5
Installation
TM-6710/6710CL High-Speed Progressive Scanning CCD Camera
2.2 Camera Setup
2.2.1 Pin Configurations
2.2.1 (a) 12-Pin Connector (TM-6710)
The TM-6710 has a 12-pin connector for power input. Pin #1 is Ground and Pin
#2 is +12V DC. The other pins handle a number of other input and output
functions, as detailed below.
2.2.1 (b) 12-Pin Connector (TM-6710CL)
The TM-6710CL has a 12-pin connector for power input. Pin #1 is ground and Pin #2 is +12V DC. The
pinout table is shown below. For the TM-6710CL, serial communication camera control is done via the
Camera Link connector on the rear panel of the camera.
Pin Description Pin Description
1 GND (Power) 7 VD In
2 +12V DC 8 N/C
3 GND (Analog) 9 HD In
4 Video Out 10 RXD (RS-232)
5 GND (Digital) 11 Integration
6 VINIT In 12 TXD (RS-232)
Pin Description Pin Description
1 GND (Power) 7 VD In
2 +12V DC 8 N/C
3 GND (Analog) 9 HD In
4 Video Out 10
RXD *
*. Optional TTL serial communications.
5 GND (Digital) 11
Integration
†
6 VINIT In †
†. VINIT and Integration can be controlled via Camera Link.
When Camera Link is connected for these uses, do not use
the 12-pin connector inputs.
12 TXD*
1
2
3
4
5
6
9
8
7 11 12
10