JVC XU-301BK - Manual (Page 7)

5
English
Digital Connections
Before proceeding, check whether the optical digital cable can be
connected.
Connect the stereo amplifier and source component to the DIGITAL
(OPTICAL) connectors on the unit using the optical digital cable.
One connecting cable is used to transmit the stereo signals (L/R)
as the digital signals.
• How to use the OPTICAL connectors for
the connections
1 Remove the protective cap.
• When the connector is not going to be used, fit this
protective cap back in position.
2 Check that the end of the optical
digital cable is not dirty, and insert
it securely.
CD player, etc.
To OPTICAL connector (OUT)
Optional optical digital cable
Input signal
Note
• When the synchro record-
ing function is to be used,
connect the CD player etc.
and unit’s ground side
using the pin cord.
XU-301BK MD-CD combination deck
To OPTICAL OUT
connector
Output signal
Optional optical
digital cable
To OPTICAL INPUT connector
Stereo amplifier with OPTICAL
connector
Before purchasing an optical digital cable (optional), make sure that the cable in question can be
connected to the amplifier, etc.
Do not bend the optical digital cable.
Red light emitted from the OPTICAL OUT connector
When the power is turned on, the inside of the connector lights up red. This light is for sending the
digital signals. Although this light will not harm your eyes, keep the protective cap in place if the
connector is not going to be used.
DIGITAL IN
OPTICAL
DIGITAL OUT
OPTICAL
LINE
MODE
VICTOR COMPANY OF JAPAN , LIMITED MADE IN JAPAN
MD TD
IN REC ( )
( )
( )
OUT PLAY ( )
L LEFT
RIGHT R ( ) 2 SLAVE UNIT
( ) 1 MASTER UNIT
TEXT COMPU LINK COMPU LINK-3
SYNCHRO
04/p04-11(E) 4/3/98, 4:45 PM 5