JVC XU-301BK - Manual (Page 27)

25
English
6 Repeat steps 4 and 5 (this procedure can be repeated for up to 16
tracks).
• The tracks on the MD alone or only the tracks on the CDs can be programmed also.
7 Press the 6 button to start MIX PROGRAM play.
• The numbers of the tracks which have been played are cleared from the music calendar, and they
are displayed when play is completed.
- Operation stops automatically when all the programmed tracks have been played.
The same operating procedure is followed for programs 2 and 3.
To cancel the programming
Press the CANCEL button. The last program setting is canceled. Press the CANCEL button repeat-
edly to cancel all the program settings.
To check the programming
To check what has been programmed while the tracks are being programmed, press the
7 (stop)
button, and use the jog dial to check.
Playing MIX PROGRAMs using the remote control ————
1 Insert the MD and CDs whose tracks are to be programmed into
the main unit.
2 Select the program mode.
Example: Program 1
• “P1 NO PROGRAM” is displayed.
3 Press the SET button.
• “P1 S01 MD 1” is displayed.
4 Select and enter the program source.
• Select one of the sources.
= MD = CD1 = CD2 = CD3 = (back to the beginning)
• When the SET button is pressed, the programming sequence and track number flash.
1 This can select the source
in the reverse direction. 2 Then press this button.
2
4 -1
7
5 · -1
4 -2 5 3 · · -2
Open the remote control’s cover.
SET
SET
07/p24-33 (E) 4/1/98, 4:43 PM 25