JVC XU-301BK - Manual (Page 42)

40
English
7 Eject the MD. \ The editing mode is now exited.
• After “UTOC WRITING” is displayed, the MD is ejected.
• The data in the memory IC has been recorded on the MD.
The editing mode can also be exited by pressing the POWER button in step 7 to turn off the power.
Once a track is erased, the recording cannot be restored.
Keep the accidental erasure prevention knob on an MD containing important recordings to the open
position.
\ See page 27.
When the wrong track is selected in step 4
Before pressing the SET button, turn the jog dial or use the number buttons on the remote control to
select the track again.
To stop ERASE at any time
Press the EDIT button. If the track has already been selected as in step 5, first press the CANCEL
button twice, and then press the EDIT button.
Do not disconnect the power cord or subject the unit to the vibration while “UTOC WRITING”
appears. Doing so may make it impossible to play the MD.
Erasing all the tracks (ALL ERASE
function)
1 Insert the MD to be edited, and set the function to “MD.”
• The number of tracks and play time are displayed.
2 Select “ALL ERASE.”
3 Press the SET button.
4 Press the EDIT button.
• “MD BLANK DISC” appears, and all the tracks are erased. The change is stored in the memory
IC.
• The function changes each
time this button is pressed.
= DIVIDE = JOIN = MOVE = ERASE = ALL ERASE =
(back to the beginning)
Flashing
XU-301 MD-CD COMBINATION DECK
REC PAUSE REC START REC DIGITAL CD
REC SOURCE SELECTOR
LINE MIC STOP
MIXING CANCEL
CD
MD
MIC
MAX MIN
PHONES
MIX BALANCE REC LEVEL
CD
LINE LINE
MIC
PLAY MODE /CHARA DISPLAY TITLE EDIT 32kHz 44.1kHz DIGITAL INPUT 48kHz
LISTENING
SKIP
1st TRACK REC
TIMER /CLOCK STANDBY
CD REC
SET
2 CD
CD 3
1 CD PLAY & EXCHANGE
3 - CD
NORMAL SPEED
CD PITCH CONTROL
POWER
EDIT
2 1
1
3 4 -1
-2
· 5
SAMPLING RATE CONVERTER
MD
EDIT
MD EDIT
ALL ERASE
EDIT
SET
L
R 40 30 15 10 20 6 3 0
MD EDIT
ALL ERASE
MD
08/p34-44 (E) 4/1/98, 5:49 PM 40